Creating a testbed
From OLPC
This article is a stub. You can help the OLPC project by expanding it.
| NOTE: The contents of this page are not set in stone, and are subject to change! This page is a draft in active flux ... |
|
This page is intended to walk people through creating an XO testbed for hardware/software testing. It is incomplete- please add your notes and ideas. Mchua
Contents |
[edit] Set up
- Get a power strip and plug all your XOs in.
- Set up your XOs on a table/counter/shelf. Make sure all the screens are visible, and (if applicable) the keyboards are accessible.
- Prepare an Activated upgrade USB key(s) for the software (firmware, build, and Activities) you're testing. Systematically reflash every XO and verify the software version.
[edit] Tools
In this section should go descriptions of all the testing/logging scripts on the XO.
[edit] Test
- Perform the test as documented.
[edit] Report
Follow the instructions on Testing and Friends in Testing for reporting results, logs, and bugs you found.
