Edit Test case: Tests/Activity/TurtleArt Movement

From OLPC

Warning: You are not logged in. Your IP address will be recorded in this page's edit history.

[edit] Test case

Name of the test case:
Category:
Sub-category:
Stream:	joyride staging update.1 ship.2 8.2 8.2.1 10.1 11.2 Any
Build:
Component being tested:
Wiki link to the feature (use [[ ]]):
Summary of the test case objective:
Tools needed for the test case:
Setup:
Procedure:	[NOTE: Each block should be connected immediately below the previous block] #Open the TurtleArt activity. #Drag a 'seth' block onto the field, and set it to -90 #Drag a 'forward' block onto the field and set its value to 150. #Drag a 'left' block onto the field and set its value to 270. #Drag a 'back' block onto the field and set its value to 150. #Drag a 'right' block onto the field and set its value to -270. #Drag a 'back' block onto the field and set its value to -150. #Drag a 'left' block onto the field and set its value to 630. #Drag a 'forward' block onto the field and set its value to -150. #Drag a 'right' block onto the field and set its value to 540. #Drag a 'forward' block onto the field and set its value to 10 000 000 000. #Drag a 'back' block onto the field and set its value to 10 000 000 000. #Drag an 'arc' block onto the field and set 'angle' to -180 and 'radius' to 75. #Run the sequence.
Expected results:	Confirm that the drawing surface: Shows a perfect square with a semi-circle on top of it. The turtle positioned at the top left corner of the square, facing the bottom of the display.
Comments:	Rationale: The equivalence partitions for the 'forward' and 'back' blocks are {Negative Number, Positive Number, Large Positive Number} The equivalence partitions for the 'left' and 'right' blocks are {Negative Number, Positive Number < 360, Positive Number > 360} It is assumed that the blocks function independently, so a member from each partition is tried once against each block. This test sequence itself follows a simple use case: the user wants to draw a box with a dome on top.

[edit] Results

Tested Release:

Tested Stream:

Tested Build:

Pass or Fail:

Associated trac tickets:

Comments: Failures *The semi-circle portion of the test drawing does not appear as expected. *The turtle itself is no longer visible after the test has run. These results are traced to steps 11 and 12: when the turtle is moved off the screen by a large number and then instructed to come back by the same amount, it doesn't come back. Using the 'print' block to show the x or y co-ordinate will print the expected value and the turtle then returns to that position upon executing the print command. Also, clicking the 'clear' button immediately after running the test sequence does not recenter the turtle at (0, 0) however using the 'setyx' command works as expected.

Today's Date:

[edit] Add new results

Click the button just above this section to add more results.

[edit] Save or preview results

Free text:

'''This page is obsolete. The information has been merged into [http://wiki.laptop.org/go/Tests/Activity/TurtleArt].''' {{delete}}{{deprecated}}

Summary::

This is a minor edit Watch this page

Cancel

Edit Test case: Tests/Activity/TurtleArt Movement

From OLPC

Contents

[edit] Test case

[edit] Results

[edit] Add new results

[edit] Save or preview results

Views

Personal tools

Search

About OLPC

About the XO

Projects

OLPC wiki

Toolbox