Screen replacement

From OLPC
Revision as of 18:50, 23 May 2008 by Ccarrick (talk | contribs)
Jump to navigation Jump to search


Pencil.png NOTE: The contents of this page are not set in stone, and are subject to change!

This page is a draft in active flux ...
Please leave suggestions on the talk page.

Pencil.png

Click the images to enlarge them as needed!

Replacing a screen is a relatively simple task. To do this, you will need a standard #1 Phillips head screwdriver and something to hold screws in (in a pinch, parts taken off the XO can serve as temporary containers).

Before we begin


Taking off the front panel

Step 1

Begin by opening the laptop and flipping the screen up. Rotate it to a 90 degree angle, similar to this. Next, remove the screws circled in blue from the bottom of the screen. There are two on each side (right/left) of the XO, so make sure to get all four.

Flip screen up
Rotate
Unscrew


Step 2

Remove the two green panels from the side of the XO by first sliding them and then lifting them off.

Screen 2a.jpg
Slide up
Lift off


Step 3

Finally, pull off the front panel, pulling it out at the bottom and then gently sliding it downwards.

Screen 3a.jpg
Screen 3b.jpg


Taking out the screen

Step 1

To get the screen out, remove the four screws highlighted in blue.

Unscrew


Step 2

Next, carefully slide the screen out, pulling the bottom out. Do not tug it or let go, as it will still be connected to the motherboard by two cables.

Slide out gently
Screen 4c.jpg
Watch out for cables!


Unhook the cable
Watch out for this little cable, too.
Good to go!



Replacing the screen

Step 1

Replace the screen by sliding the connection cables into place and clipping them back down (it is generally easier to clip the thinner one that has a longer tether first). Reseat the screen, making sure that it sits flat and that none of the spacers is gone.

Error creating thumbnail: File missing
Clip little cable in
Clip big cable in


Gently slide screen back in
The screws with the large heads (4) go back in


Step 2

Slide the front panel back on, making sure that it sits flat. Note that there are hooks on the side of the panel (highlighted in blue) that need to slide into place; pushing the top of the screen flat and sliding it upwards works well.

Watch out for these hooks
The rest of the panel slides into place


Step 3

Slide the green side pieces back into place. Then, rotate the XO 90 degrees and put the remaining screws back. Don't forget that the screws go in on both sides (right/left).

Screen 7a.jpg
Side panels slide back in place
Almost there!


Rotate
Put screws (4) back in.


And you're done! Yay! :D