XO1.5 WLAN power ECO

From OLPC
Revision as of 13:54, 9 October 2009 by Wad (talk | contribs) (New page: =Scope= This describes a change to early prototypes of the XO-1.5 motherboard. It fixes a problem with the VX855 chip maintaining power on one of it's SDIO ports when the s...)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigation Jump to search

Scope

This describes a change to early prototypes of the XO-1.5 motherboard. It fixes a problem with the VX855 chip maintaining power on one of it's SDIO ports when the system enters suspend. Boards without this ECO will loose their wireless network interface after being suspended.

This only applies to XO-1.5 B2 phase motherboards.

Problem Description

The third SDIO port on the VX855 can't maintain power through a suspend. This ECO moves the control pin to the unrelated GPIO2 (MSDT) output, U19.AL20.

Procedure

  1. Cut the trace between the via and Q38, pin 2.
  2. Wire Q38, pin 2 to WLAN_EN#, at the side of R321 that does not connect to +3.3VSUS.