USB Sensor: Difference between revisions
Edwardbaafi (talk | contribs) No edit summary |
Edwardbaafi (talk | contribs) |
||
Line 38: | Line 38: | ||
Board based on the [http://http://www.obdev.at/products/avrusb/easylogger.html AVR USB - EasyLogger] reference design |
Board based on the [http://http://www.obdev.at/products/avrusb/easylogger.html AVR USB - EasyLogger] reference design |
||
<br> |
<br> |
||
Eagle board file is available [http://fabuntu.org/downloads/USB_Sensor.brd here] and schematic is available |
Eagle board file is available [http://fabuntu.org/downloads/USB_Sensor.brd here] and schematic is available [http://fabuntu.org/downloads/USB_Sensor.sch here] |
||
Firmware is available [http://www.obdev.at/ftp/pub/Products/avrusb/EasyLogger.2008-02-28.tar.gz here |
Firmware is available [http://www.obdev.at/ftp/pub/Products/avrusb/EasyLogger.2008-02-28.tar.gz here] |
||
====TO DO==== |
====TO DO==== |
Revision as of 01:18, 11 March 2008
This page talks about the development of a Super Low Cost USB based sensor board
People
This board was designed by Edward Baafi and based on discussions with Arjun Sarwal and David Cavallo
Rationale
The XO has a unique feature which allows the microphone input to be used as a general purpose sensor input.
This is a very powerful concept as many sensors can be connected for <$2..
There are some limitations with this approach such as:
1) Only one analog input possible
2) No output is possible
3) No possibility to decouple sensor from pc for long term acquisition..
4) TODO - add other limitations
This low cost sensor input is being developed to address these limitations and explore other possibilities
Cost
~$2 of parts
Input/Output
3ADC/GPIO pins
1 GPIO only pin
Features
No special USB Connector - Board IS the USB connector
No USB Hardware - Firmware based USB stack (based on low cost ATTiny45 Microcontroller)
Reprogrammable / Extensible
Current Status
Current firmware only uses one of the four I/O pins as sensor input (1 pin used for LED which indicates state, 1 pin used for button to start operation)
Sensor board shows up as a usb keyboard and dumps data as if typing from keyboard
Single layer board to make possible homemade boards using chemical etch, or mechanical milling (see pics below)
Board based on the AVR USB - EasyLogger reference design
Eagle board file is available here and schematic is available here
Firmware is available here
TO DO
Update firmware to use 4 pins (3 ADC / 1 Digital In)
Develop/adopt scheme to implement USB CDC device and access through pyUSB (libUSB wrapper) and update firmware
Make CDC device available to Measure/Etoys/Scratch
Update board to drop hardwired button and led (could always be added by user) and reduce size of board
Building It
The USB Sensor can be mechanically etched using a 3 axis milling machine.. The following shows the process using a Roland Modela Desktop Mill available in FabLabs..