XO1.75 EC Breadboard: Difference between revisions
No edit summary |
No edit summary |
||
| Line 3: | Line 3: | ||
==Documentation== |
==Documentation== |
||
[[Image:XO1.75_EC_Breadboard_Block.png| |
[[Image:XO1.75_EC_Breadboard_Block.png|400px]] |
||
* [[Media:XO1.75_EC_Breadboard_Block.pdf|Block Diagram (PDF)]] |
* [[Media:XO1.75_EC_Breadboard_Block.pdf|Block Diagram (PDF)]] |
||
Revision as of 04:06, 13 October 2010
This page describes an engineering prototype used briefly during the bringup of the XO-1.75 design, in order to further software development of the Embedded controller and the XO-1.75 Host/EC communications protocol.
Documentation
The breadboard is powered by any XO power supply.
Construction
The heart of the breadboard is a ZIF socket for the 0.4 mm pin pitch 128 pin QFP package used by the KB3930. This is part number PA-QFE128SD-C-Z-02W, purchased from Ironwood Electronics. It includes an adapter PCB, and a wire-wrap adapter attached to that. This was mounted on a piece of 0.1" perfboard, onto which the required connectors and switches were epoxied.
Copper tape was used to supply +3.3V and ground. A sprinkling of 0.1 uF SMD-1206 caps provides decoupling between these.