Talk:Measure: Difference between revisions

From OLPC
Jump to navigation Jump to search
m (USB ports)
Line 20: Line 20:
See [[Electrical output]] for further discussion of this and related possibilities...
See [[Electrical output]] for further discussion of this and related possibilities...


Im guessing that it would be better to manage the USB ports, because the XO has three of this inputs/outputs, also there are thousands of electronics applications especially designed to USB [[user:RafaelOrtiz]]
== Maximun frecuencies ==
== Maximun frecuencies ==



Revision as of 15:16, 15 August 2007

quote

It is said "Give the child a hammer, and the world are his nails".

I need the source for this, I remember hearing it somewhere.--Arjs 12:11, 20 July 2007 (EDT)

line voltage

Never minding the fact that all round (non-USB) ports should tolerate line voltage, how might one make a safe connection? This is useful for showing line frequency and for showing the waveform. Waveforms from UPSes might be particularly interesting. Not being an EE, I can think of a few ideas: transformer, capacitor, resistor. Each of those can be done nicely, with proper electronic parts, or crudely with makeshift parts. 24.110.144.116 00:42, 1 August 2007 (EDT)


Measuring voltages outside 0.3V - 1.9V would require an external probe, the development of which is also in the pipeline.--Arjs 02:37, 15 August 2007 (EDT)

What about the reverse?

Measure turns the audio input into a generic input over a certain voltage range with essentially 0 current. Would it be possible to do the same for the audio output? This could run simple robotics, or allow switching between sensors. Obviously it would NOT be usable as a DC power source, just for switching transistors. Homunq 20:38, 7 August 2007 (EDT)


I have been thinking about that too. It would be interesting if I am able to achieve that. One of the other things that I have been thinking about is a simple generic USB based I/O interface. USB to Parallel chips aren't that expensive too...--Arjs 02:35, 15 August 2007 (EDT)

See Electrical output for further discussion of this and related possibilities...

Im guessing that it would be better to manage the USB ports, because the XO has three of this inputs/outputs, also there are thousands of electronics applications especially designed to USB user:RafaelOrtiz

Maximun frecuencies

hi Arjs where can i find the specs of measure..i.e maximum frequencies and stuff..?


The maximum sampling rate of the Ad188 sound chip is 48khz , which is the sampling rate I am using. I would say that maximum frequency would be about - 15Khz (slightly less than Fs/2). --Arjs 02:19, 15 August 2007 (EDT)