XO1.5 1.2VSUS power sequencing ECO: Difference between revisions

From OLPC
Jump to navigation Jump to search
(New page: =Scope= This describes a change to early prototypes of the XO-1.5 motherboard. It fixes a problem with the sequencing of power supply turn-on to the VX855 chip, which preve...)
 
No edit summary
 
(4 intermediate revisions by the same user not shown)
Line 12: Line 12:
=Procedure=
=Procedure=


# Cut trace between PU5, pin 3 and Vin (keeping PC54 connected to pin 3).
# Lift PU5, pin 3 from its pad.
# Run wire from PU5, pin 3 to 3VPCU
# Run wire from PU5, pin 3 to 3VPCU (anode of D19, next to Q22)
# Cut trace at top of PR70, and tie to +5VSUS
# Cut trace at top of PR70, and tie to +5VSUS (at PU5, pin 4 or PC31).
# Lift Q22, pin 1 emitter, removing it from the VR_ON net. Tie Q22, pin 1 to +1.2VSUS_GD (PU5, pin 1 or PR70).
# Lift Q22, pin 2 (base), removing it from the 3VPCU net. Tie Q22, pin 2 to +1.2VSUS_GD (PU5, pin 1 or PR70).
# Replace PR6 with a 56.2K resistor
# Replace PR6 ("top" side) with a 56.2K resistor
# Add a 0.1 uF capacitor from PU1, pin 11 (PR6) to ground
# Add a 0.1 uF capacitor from PR6 (thick trace) to ground (one side of PR7)


=Results=
=Results=
Line 24: Line 24:


[[Category:Hardware]]
[[Category:Hardware]]
[[Category:XO-1.5]]

Latest revision as of 05:44, 9 August 2009

Scope

This describes a change to early prototypes of the XO-1.5 motherboard. It fixes a problem with the sequencing of power supply turn-on to the VX855 chip, which prevents power up. Boards having this problem will occasionally fail to turn on, indicated by the EC flashing the red battery charge LED.

These power issues are not exacerbated by suspend/resume testing.

This only applies to XO-1.5 A-phase (both A1 and A2) motherboards.

Problem Description

Procedure

  1. Lift PU5, pin 3 from its pad.
  2. Run wire from PU5, pin 3 to 3VPCU (anode of D19, next to Q22)
  3. Cut trace at top of PR70, and tie to +5VSUS (at PU5, pin 4 or PC31).
  4. Lift Q22, pin 2 (base), removing it from the 3VPCU net. Tie Q22, pin 2 to +1.2VSUS_GD (PU5, pin 1 or PR70).
  5. Replace PR6 ("top" side) with a 56.2K resistor
  6. Add a 0.1 uF capacitor from PR6 (thick trace) to ground (one side of PR7)

Results

Retrieved from "http://wiki.laptop.org/mediawiki/index.php?title=XO1.5_1.2VSUS_power_sequencing_ECO&oldid=214347"