OLPC Firmware Q2A42: Difference between revisions
Jump to navigation
Jump to search
(Initial revision) |
(fixed some links) |
||
| Line 3: | Line 3: | ||
This is the production release for the B-test build. |
This is the production release for the B-test build. |
||
Image:Olpc-Q2A42.rom |
[[Image:Olpc-Q2A42.rom]] |
||
MD5 |
MD5 |
||
2f7a1bb56ed76e5b3274bab37c239fed olpc-Q2A42.rom |
2f7a1bb56ed76e5b3274bab37c239fed olpc-Q2A42.rom |
||
Image:Olpc-ofw-18.tgz |
|||
=== Installation Caveats === |
=== Installation Caveats === |
||
Revision as of 19:15, 16 November 2006
OLPC Firmware Production Release Q2A42 - 2006-11-12
This is the production release for the B-test build.
MD5 2f7a1bb56ed76e5b3274bab37c239fed olpc-Q2A42.rom
Installation Caveats
- If you use olpcflash to write this image, you must use the --brick option.
- After you reflash, you must power cycle by physically removing power from the system. A warm-start or button-induced restart is not sufficient.
Known issues
- Some USB keyboards don't work behind a hub.
- At least one USB keyboard dosen't work at all
- Auto-repeat is slow on some USB keyboards
- NVRAM storage for configuration variables is not yet implemented.
- JFFS2 does not pay attention to the bad block table.
- JFFS2 does not handle ECC
- The boot menu is incomplete
- Network drivers are not present
- The new recipe for poweroff (using ACPI register PM1_CNT to ask SB to turn off main_on&sus_on) is not yet implemented.
- Dirctory symlinks have a problem.