Tests/Activity/TurtleArt Boolean Logic 1: Difference between revisions

From OLPC
Jump to navigation Jump to search
No edit summary
No edit summary
 
Line 1: Line 1:
'''This page is obsolete. The information has been merged into [http://wiki.laptop.org/go/Tests/Activity/TurtleArt].''' {{delete}}{{deprecated}}

{{Test case
{{Test case
|testcase_name=Boolean Logic 1
|testcase_name=Boolean Logic 1

Latest revision as of 01:31, 17 March 2012

This page is obsolete. The information has been merged into [1].

  Trashcan.png A request has been made for this page to be deleted.
If you disagree with its deletion, please explain why on its talk page.
Before deleting verify that no links will break.
Stop hand.png WARNING:
The content of this section is considered
DEPRECATED and OBSOLETE
It is preserved for historical or documenting reasons.


Stream ,|x|Build stream::x}}
Category Test category::Activity Sub-category Test subcategory::TurtleArt
Component System component::TurtleArt
Feature System feature::http://wiki.laptop.org/go/Turtleart
Objective Test objective::Tests 'Greater Than', 'Less Than' and 'Equals' functional blocks.
Tools Test tools::None
Setup [[Test setup::--
  1. Open the TurtleArt activity.
  2. Drag an 'if' block onto the field.
  3. Drag a spacer to the 'then' area of the 'if' block.
  4. Drag a 'forward' block to the bottom of the spacer.
  5. Drag a 'back' block into the 'else' area of the 'if' block.]]
Procedure [[Test procedure::Test Procedure (repeat for all test values below):
  1. Click the 'clean' button at the top of the screen.
  2. Drag the specified block-under-test into the 'if' block's condition area.
  3. Drag a 'number' field into the left position of block-under-test and set it to the value specified by the test (Left).
  4. Drag a 'number' field into the right position of block-under-test and set it to the value specified by the test (Right).
  5. Run the sequence.
  6. The turtle should move either up or down. Make sure the direction of movement matches the expected direction.

Test Values:

#LeftRight
[Equal]
1.-999-999
2.234234
3.00
[Left > Right]
4.-34-56
5.0-56
6.23-56
7.230
8.233
[Left < Right]
9.-78-34
10.-780
11.-7811
12.011
13.411
]]
Expected Results
and Pass Criteria
[[Pass criteria::--
Block'Equal' Partition'Left > Right' Partition'Left < Right' Partition
">" down up down
"<" down down up
"=" up down down
]]
Comments [[More notes::Rationale:
  • The inputs are chosen from the equivalence partition { Negative, Zero, Positive }
  • Input combinations were chosen to give a variety of outputs, for each partition. Boundary values are also tested.]]
Release Stream Build Pass/Fail Trac Ticket(s) Comment(s) Date of Test
Software release::8.2.0 (767) Build stream:: Build number::45 PassFail::Pass ,|x| #x}} Comments::All blocks exhibit the expected behavior Created::2009/03/29