XO1.5 1.2VSUS power sequencing ECO: Difference between revisions

From OLPC
Jump to navigation Jump to search
Line 14: Line 14:
# Cut trace between PU5, pin 3 and +1.8VSUS near C355 (keeping PC54 connected to pin 3).
# Cut trace between PU5, pin 3 and +1.8VSUS near C355 (keeping PC54 connected to pin 3).
# Run wire from PU5, pin 3 to 3VPCU (anode of D19, next to Q22)
# Run wire from PU5, pin 3 to 3VPCU (anode of D19, next to Q22)
# Cut trace at top of PR70, and tie to 3VPCU (at PU5, pin 3 or PC54).
# Cut trace at top of PR70, and tie to +5VSUS (at PU5, pin 4).
# Lift Q22, pin 1 emitter, removing it from the VR_ON net. Tie Q22, pin 1 to +1.2VSUS_GD (PU5, pin 1 or PR70).
# Lift Q22, pin 1 (emitter), removing it from the VR_ON net. Tie Q22, pin 1 to +1.2VSUS_GD (PU5, pin 1 or PR70).
# Lift Q22, pin 2 (base), removing it from the 3VPCU net. Tie Q22, pin 2 to +5VSUS (at PU5, pin 4).
# Replace PR6 ("top" side) with a 56.2K resistor
# Replace PR6 ("top" side) with a 56.2K resistor
# Add a 0.1 uF capacitor from PR6 (thick trace) to ground (one side of PR7)
# Add a 0.1 uF capacitor from PR6 (thick trace) to ground (one side of PR7)

Revision as of 03:54, 18 July 2009

Scope

This describes a change to early prototypes of the XO-1.5 motherboard. It fixes a problem with the sequencing of power supply turn-on to the VX855 chip, which prevents power up. Boards having this problem will occasionally fail to turn on, indicated by the EC flashing the red battery charge LED.

These power issues are not exacerbated by suspend/resume testing.

This only applies to XO-1.5 A-phase (both A1 and A2) motherboards.

Problem Description

Procedure

  1. Cut trace between PU5, pin 3 and +1.8VSUS near C355 (keeping PC54 connected to pin 3).
  2. Run wire from PU5, pin 3 to 3VPCU (anode of D19, next to Q22)
  3. Cut trace at top of PR70, and tie to +5VSUS (at PU5, pin 4).
  4. Lift Q22, pin 1 (emitter), removing it from the VR_ON net. Tie Q22, pin 1 to +1.2VSUS_GD (PU5, pin 1 or PR70).
  5. Lift Q22, pin 2 (base), removing it from the 3VPCU net. Tie Q22, pin 2 to +5VSUS (at PU5, pin 4).
  6. Replace PR6 ("top" side) with a 56.2K resistor
  7. Add a 0.1 uF capacitor from PR6 (thick trace) to ground (one side of PR7)

Results

Retrieved from "http://wiki.laptop.org/mediawiki/index.php?title=XO1.5_1.2VSUS_power_sequencing_ECO&oldid=212429"