XO 1.75 11089 Fix: Difference between revisions

From OLPC
Jump to navigation Jump to search
Line 16: Line 16:
The serial port to use is UART3 (CN8). There is a [[Media:XO_1.75_Connectors_B1.pdf|chart showing the location]], and this photo:
The serial port to use is UART3 (CN8). There is a [[Media:XO_1.75_Connectors_B1.pdf|chart showing the location]], and this photo:


[[Image:1.75_serial_connector.png|400px|center]]
[[Image:1.75_serial_connector.png|500px|center]]


[[Category:Hardware]]
[[Category:Hardware]]

Revision as of 00:24, 5 August 2011

  This page is monitored by the OLPC team.

Version Q4B05 of Open Firmware for the XO 1.75 B1 laptop had a bug (<trac>11089</trac>) which causes the laptops to boot up with a white screen if it has been ten days since their manufacture, or if the RTC battery is removed. The symptom is a white screen (nothing on it) on boot.

The Fix

Fortunately, the fix to this is simple (yet tedious):

  1. Disassemble the laptop to access the motherboard (the heat spreader does not have to be removed).
  2. Plug in a serial cable (see below, and a USB key with Q4B06 or later.
  3. Boot the laptop. It should print out Unrecognized SPI Flash ID and provide an ok> prompt.
  4. Type "dir u:" to initialize the USB stack.
  5. Type "flash! u:\q4b06.rom". When the laptop finishes reflashing and returns an ok>, either reboot (type "bye") or poweroff the laptop.


Finding the Serial Port

The serial port to use is UART3 (CN8). There is a chart showing the location, and this photo:

1.75 serial connector.png