Talk:Measure: Difference between revisions

From OLPC
Jump to navigation Jump to search
(→‎What about the reverse?: dc output from audio port?)
m (maximun frecuencies)
Line 11: Line 11:
Measure turns the audio input into a generic input over a certain voltage range with essentially 0 current. Would it be possible to do the same for the audio output? This could run simple robotics, or allow switching between sensors.
Measure turns the audio input into a generic input over a certain voltage range with essentially 0 current. Would it be possible to do the same for the audio output? This could run simple robotics, or allow switching between sensors.
[[User:Homunq|Homunq]] 20:38, 7 August 2007 (EDT)
[[User:Homunq|Homunq]] 20:38, 7 August 2007 (EDT)

== Maximun frecuencies =

hi [[User:Arjs|Arjs]] where can i find the specs of measure..i.e maximum frequencies and stuff..?

Revision as of 16:58, 10 August 2007

quote

It is said "Give the child a hammer, and the world are his nails".

I need the source for this, I remember hearing it somewhere.--Arjs 12:11, 20 July 2007 (EDT)

line voltage

Never minding the fact that all round (non-USB) ports should tolerate line voltage, how might one make a safe connection? This is useful for showing line frequency and for showing the waveform. Waveforms from UPSes might be particularly interesting. Not being an EE, I can think of a few ideas: transformer, capacitor, resistor. Each of those can be done nicely, with proper electronic parts, or crudely with makeshift parts. 24.110.144.116 00:42, 1 August 2007 (EDT)

What about the reverse?

Measure turns the audio input into a generic input over a certain voltage range with essentially 0 current. Would it be possible to do the same for the audio output? This could run simple robotics, or allow switching between sensors. Homunq 20:38, 7 August 2007 (EDT)

= Maximun frecuencies

hi Arjs where can i find the specs of measure..i.e maximum frequencies and stuff..?