Talk:Notes on using the OLPC developer boards

Where are the specifications for the rest of the connectors on the board? The only two I've discerned from the Wiki so far are the obvious ones:

• IO for serial breakout (U20? numbering unclear)
• CON_ANT1
• CON_ANT2
• USB: CN4, CN6, CN7

Some of the development board photos show PS keyboard/mouse wired in, where would those connect? To CN23 - the pinout is shown below.

Could somebody also identify the connector type for the antenna? These are U.FL connectors.

Connectors/LEDs

• CN1: JTAG Connector for Marvell wireless chip.
• CN2: Old LCD Connector. Definition changing.
• CN8: Mono right side speaker connector
• CN9: Internal stereo speaker connector
• CN14: Used for DCON Debugging. Definition changing.
• CN15: Internal microphone connector
• CN16: AMD Geode JTAG Connector
• CN17: Used for DCON Debugging. Definition changing.
• CN18: CRT/LCD Jumper
• CN19: Unused
• CN20: Used for manufacturing (serial Flash programming)
• CN21: Battery connector (Pin 1: Gnd, 2: VBat)
• CN22: Battery sensor. Definition changing.
• CN23: Internal PS/2 Connector to keyboard & input module (Pin 1: TP Data, 2: TP Clk, 3: Gnd, 4: KB Data, 5: KB Clk, 6: Power [3.3V or 5V])
• CN??: Unused large solder pads (was mini-PCI on pre-A-Test boards)
• D2: LED. Definition changing.
• D3: LED. Definition changing.
• D4: LED. Definition changing.
• D21: LED. Definition changing. Same output as D3 (front/back view)
• D22: LED. Definition changing. Same output as D2 (front/back view)
• D23: LED. Definition changing. Same output as D4 (front/back view)

NOTE: Just because it doesn't say it's changing above, doesn't mean that it won't change!