Talk:XO LiFePO4 Recovery Procedure

dont know where i get ot here but ok ill try:

well folks, just after a glance at the vast detail of the recovery procedure guys i suppose i am right to post right HERE:

what i did:

i opened the lid of the batterie pack and after a while i did it:

i changed the two lifepo4 for 4 standard liion 18650

and ok, i runs...

cant well tell -normally the capacity should be DOUBLE!!

can someone of the hard/software guys enlighten us what about "smart batterie" status of the xo1 <-> batteries

is there ANY??

i prefered to SWITCH SUCH COMPLETELY OFF -if POSSIBLE

(and yes i know i then have to watch ot about the voltage etc.. not to talk about danger explosion, fires ... blah blah...)

but the advantage is:

more power, use of ANY used batteries from scrap, as there are a lot out there worldwide...!!!

if you want i can make pics of my mod... allows single batterie change in a second, lid closes well, these two mechanisms are well suited for!!!

and: yes sirs, did same at my eeepc, too: works, too!! , thomas@biopilze.de

VERY bad idea!

The XO charging system is not designed to charge the Li Ion batteries found in most laptops. Not only will it not effectively charge Li cobalt batteries its extremely dangerous. You have created an extreme safety hazard for yourself. Mis-charging lithum colbalt batteries will result in explosion.

(reasked by thomas@biopilze.de: please explain: what is the problem? out of my experience with older 18650s LiIon-batteries seem to withstand even higher voltages (happened about 4.4v) without problems (yet)... and: i had only put these older 18650-s loosely into the batterie-slot in the xo, this results in bad contact -so NORMALLY the cells just WONT CHARGE completely... -SO WHERE IS THE D A N G E R man??? -CANT SEE it YET!!!, thomas)

i've an other problem

my battery did not charge full, so when i try to run bat-recover to fix that, i get the response: no response from battery see-bstate responde: ff and xo hangs up watch-battery gives "normal" information...

any ideas?