Difference between revisions of "Voltage Testing of XO-1.75"
(Testing at lower voltage) |
(No difference)
|
Revision as of 05:12, 13 July 2011
This procedure is for verifying firmware startup at different core voltages.
It assumes that the board is hardware-configured to start at a core voltage of 1.4V.
Test booting at 1.4V by powering on the board in the normal way.
To test booting at 1.345V :
- Attach a serial port to the XO-1.75.
- Get into CForth by holding down the rotate key and powering on.
ok b gpio-set ok ofw
It should boot normally.