OLPC Firmware q2c25: Difference between revisions

From OLPC
Jump to navigation Jump to search
(Q2C25)
 
Line 16: Line 16:
In some previous firmware versions, pressing any game key would get you to interactive mode; in this version, only the "X" game key, which is the one nearest to the power button, does so.
In some previous firmware versions, pressing any game key would get you to interactive mode; in this version, only the "X" game key, which is the one nearest to the power button, does so.


== Changes since [[OLPC Firmware q2c23]] ==
== Changes since [[OLPC Firmware q2c24]] ==


=== OpenFirmware is r568 ===
=== OpenFirmware is r568 ===

Revision as of 02:16, 19 August 2007

OLPC Firmware Release q2c25 - 2007-08-18

This firmware is a development release, replacing Q2C24 which is withdrawn. It works on B1 and later systems. Do not use it on pre-B1 boards - it will brick them because of the EC microcode. It does not work on Atest because support for Atest has been eliminated from the EC microcode.


Download: q2c25


How to get the ok prompt

Power & Game buttons

Press the "X" (down) game key after hitting the power button to enable the ok prompt. You still have to press the ESC key (upper left on the keyboard Key esc.jpg) during the countdown. If you don't press the "X" game key, the firmware goes into fastboot mode, in which:

  • The keyboard is not probed, thus saving some time
  • The boot order is USB, SD, NAND, wireless
  • OFW does not put any text on the screen, just graphics

In some previous firmware versions, pressing any game key would get you to interactive mode; in this version, only the "X" game key, which is the one nearest to the power button, does so.

Changes since OLPC Firmware q2c24

OpenFirmware is r568

  • Fixed bug that caused Q2C24 to brick B2 machines
  • Improved reliability of "clone" command (for unbricking another XO system)
  • Added game key for "pretty boot" testing (direction - left)

EC code is PQ2C24

<same as previous release>

Installation Instructions

  • If you have a B1-B4 system:
    • Detailed upgrade instructions are located here.
    • If your firmware version is earlier than the version in Auto Install Image then you can just use that procedure for the update.
      Note: that this procedure will also upgrade the image in your nand flash -- which is the entire Linux operating system and all the files you may have edited or saved. This means it will ERASE what is in your nand and re-write it. So you will lose any data you have stored on the filesystem unless you back it up. If you do not want your files erased, then please use the first procedure above.
    • Do NOT use olpcflash to write new firmware images. Doing so will erase the manufacturing data that was added at the factory.
    • After you reflash, you must power cycle by physically removing power from the system. A warm-start or button-induced restart is not sufficient. Please remove both the battery pack and wall adapter for 10 seconds.
  • If you have an ATest system
    • Don't use this firmware. ATest support has been removed.