Tests/SmokeTest/StartUp

Stream	,\|x\|Build stream::x}}
Category	Test category::SmokeTest	Sub-category	Test subcategory::Start Up
Component	System component::boot up features
Feature	System feature::
Objective	Test objective::Boot up your XO unit to see if it can successfully connect to the various networks available within 1CC.
Tools	Test tools::XO unit
Setup	Test setup::
Procedure	[[Test procedure::Actions Boot the laptop Connect to a school server AP (such as xstest), WEP ("canopy"/ASCii pswrd:'xoxoxoxoxoxox') and WPA ("olpc" pswrd:'xoxoxoxo') access points]]
Expected Results and Pass Criteria	[[Pass criteria::Verify If in secure mode: the laptop shows pretty boot (only with stable builds) The laptop boots into sugar The journal loads The laptop connects to one of the following (whichever one is highest on the list and available to the laptop) A school server - If there is a school server present, the laptop MUST be tested against the school server. If it cannot connect to the school server, that is a major failure. A preferred AP An MPP A local mesh The XO should connect properly to a WEP or WPA enabled AP]]
Comments	More notes::

Release	Stream	Build	Pass/Fail	Trac Ticket(s)	Comment(s)	Date of Test
Software release::Candidate	Build stream::8.2	Build number::760	PassFail::Pass	,\|x\| #x}}	Comments::	Created::
Software release::Candidate	Build stream::8.2	Build number::762	PassFail::Pass	,\|x\| #x}}	Comments::	Created::
Software release::Candidate	Build stream::8.2	Build number::763	PassFail::Pass	,\|x\| #x}}	Comments::however, WPA networks were not accessible, not sure if this is XO issue or network issue.	Created::

Navigation menu