Oscilloscope adaptor

From OLPC
Revision as of 18:26, 20 September 2007 by DyD (talk | contribs)
Jump to navigation Jump to search

Goal: To take input from .3-16v to .3-2.0v

Ideas:

Voltage Divider w/ Zener

  • Use a resistor-based voltage divider that divides by eight, reducing 16 volts to 2 volts.
    • Using precision surface-mount resistors on a PCB with a heat-sink
      • Use body of probe as heatsink, if conductive enough.
  • Use a 2.2v zener diode with a voltage dependent switch to enable the measuring of voltages less than 2.4v(.3*8)
    • This method would require the child to recognize high(above 1.9v) and low(below 1.9v) voltages, and to adjust a switch accordingly.