Insecure Upgrade

This page is on how to re-flash an insecure laptop.

1. First ensure you have a power adapter AND battery plugged into the laptop.
2. For B3 or B4 units that have a really old build (406.14), you need to first flash the firmware
   1. Press the power button and hold all four gamekeys; then hit ESC when you get the message that you have 3 seconds to hit escape.
   2. Insert a USB key with the latest Firmware on it
   3. At the OK prompt type: 'flash u:{path_to_rom}'
   4. When it powers down hold the power button until it stays off (it will want to reboot).
3. To put the latest signed image on the laptop, follow these steps
   1. Create a USB key with the os{number}.img and fs.zip file at the root.
      • You can get these files from official releases
   2. Insert the usb key into the shut down laptop.
   3. If you are not up to the latest firmware, Power up the laptop while holding the X button (forces secure boot)
   4. When it says 'release the game keys', release the button.
      • The laptop will rewrite the flash and reboot the laptop.
      • Hit esc to get to the ok prompt, and powerdown the laptop (hold the power button)
   5. With the usb key inserted, power up while holding all four game buttons.
   6. When it says 'release the game keys', release all buttons.
      • This will re-write the nand image.
   7. Once done with the nand re-flash, the laptop will reboot, and get to a prompt for a name.
   8. Press the Alt+Ctrl+Mesh keys together to get to the terminal, and check that the laptop is at the version you wanted.
   9. Type root, enter, and poweroff to shut down the laptop.
4. To put a development build on the laptop, follow these steps
   1. Create a USB key based on the page Autoreinstallation image
      • Specifically, the section Preparing_the_autoupdate_image
   2. Insert the USB key into the laptop
   3. If you aren't at the latest firmware, follow the steps above for flashing the firmware on B3, B4, etc...
   4. Power up the laptop while holding the square button.
      • This will re-flash the nand image.
   5. When the laptop is done re-flashing, it will reboot the laptop up to the prompt for a name.
   6. Press the Alt+Ctrl+Mesh keys together to get to the terminal, and check that the laptop is at the version you wanted.
   7. Either shutdown the laptop by typing, root, enter, poweroff, or press Alt+Ctrl+Home to go back to the name prompt, and continue with the booting process.