Secure Digital card

From OLPC
Revision as of 06:26, 29 December 2007 by 68.0.226.163 (talk) (Oh yeah, 2^9 is 512!)
Jump to navigation Jump to search
This article is a stub. You can help the OLPC project by expanding it.

The XO laptop has 1 MMC/SD/SDHC slot. 8-gigabyte memory cards work. As larger cards are created, they will also be tested (-gnu).

XO uses a custom microchip for SD card access, Camera and Flash Enabler, or CaFE. CaFE includes SDHC support. SDHC is compatible at a hardware level with SD. Pierre Ossman wrote the Linux driver support for SDHC. SD cards up to something like 256 GB should be supported. cafe is driven by the sdhci driver. cafe follows the standard host controller interface for SD controllers.

Here is how SD block addressing works: The address is 32 bits. In the CaFe chip, which is compatible with the standard "SDHCI" spec, the address goes in the 32-bit chip register at offset 8. For old SD cards (not the new SDHC - High Capacity cards), the address is a byte address, so the maximum size is 4 Gbytes. For the newer SDHC cards, the address is a block number, assuming 512 byte blocks, so the maximum size is 2 TBytes. None of this is CaFe-specific, BTW. It is standard SD. In other words, SDHC just shifts the addresses by nine bits, allowing an effective 40 bit address. The other limit that's often written about, 32GB, is an artificial limit in Window's FAT formatter; Windows will use the generally incompatible NTFS instead. Linux can format FAT up to the ~300GB real limit just fine, after that we'll need to use a linux specific fs.


Question: 16GB cards are starting to show up, I assume they *should* work, but has anyone tried one?

Yes, there is at least one report of 16GB SDHC cards working. —Joe 13:59, 27 December 2007 (EST)


SD cards and USB flash drives are automatically mounted in the Journal activity. The Journal entry shows you how to access the add-on memory devices. You can move files to and from the storage media. Paul Bock 13:56, 19 December 2007 (EST)

ANOTHER QUESTION: I Installed (2) different USB sticks on my new XO and also a miniSD(with SD adapter) and none of these (3) items are showing up in the Journal. I'm unable to access any of these and don't understand what I'm doing wrong. The USBs are both U3 Launchpad enable (only one is password protected). How can I make these Items work? A: Make sure both cards have different Volume labels, as that's how they're assigned a mount point. See [1]


Note: The SD/MMC/SDHC memory card will only mount when inserted properly into the XO laptop. The slot will allow you to insert the card in either direction however.

To properly insert the SD/MMC/SDHC card the brass fingers on the card should be facing up and towards the front of the LCD screen. Insert the card until it is flush with the bottom of the screen, you will hear a click when the card is fully seated. [I had a hard time getting the card come out again. Using small tweezers I finally succeeded. Next time I attach a little piece of scotch tape to the SD card; this will give me an easy handle to pull the card out when it gets stuck. Geert December 28, 2007]

The picture below shows the proper way to insert the SD/MMC/SDHC card:


Proper SD Card Insertion.jpg

--KenXo 11:28, 24 December 2007 (EST)



Wikipedia