XO Flash Bad Blocks
This page is how to fix an XO laptop which is having problems with its main Flash ROM storage.
Problem Description
The NAND Flash which provides the primary storage for a laptop (it is used for Linux and Sugar) has blocks of the chip which don't work. Usually, these are identified at the factory (using an extremely sensitive test) and don't change over the life of the device. Occasionally, however, a device develops additional bad storage blocks. If a laptop has had repeated problems where the solution was reinstalling the software, the bad block table may need to be rebuilt.
Repair
You can ask Open Firmware to check the NAND Flash ROM and add newly-bad blocks to the "bad block table" that tells the system not to use them. This requires a developer key for the laptop.
Using firmware Q2D16 or earlier
If you are using Open Firmware Q2D16 or earlier, the procedure requires that you type a few lines because of a firmware bug:
ok dev /nandflash ok : xx dup aa ; ok patch xx aa full ok dend ok test /nandflash::fixbbt
=Using firmware Q2D17, Q2E01 or later
If your Open Firmware is newer than Q2D16, just type:
ok test /nandflash::fixbbt
This procedure takes several minutes, because it tests every block on the NAND Flash with several data patterns. The procedure is safe for good NAND Flash, because it saves the previous block data before the test and restores it afterwards, so you won't lose any data on good Flash blocks. There is, however, a small chance of data loss in the event that a block goes bad during (i.e. as a result of) the test, preventing restoration of the previous contents.