OLE Nepal/Deployment guide
Jump to navigation
Jump to search
LOGISTICS
- If possible, count the number of XO's at the airport and note any physical damage
- Transport XO's to storage area
- Write the serial number with a marker at the underside of the XO. The serial number can be found after removing the battery. (e.g SHF8060099D)
- Assign a label to the XO (e.g OLEN.XO.1) make sure that both the label and the serial number has been noted in paper.
- You can use a marker and a tape to stick the label at the front of the XO.
- The label is best put in the green cover on top of the screen, between the two antennas.
- Laptops should be kept systematically with a certain range of XO's in a certain shelf. (e.g OLEN.XO.1 - OLEN.XO.10 should be kept in the same shelf)
- Activate all laptops. (http://wiki.laptop.org/go/Activation_and_Developer_Keys#Getting_devkey_data_via_USB_stick)
- Power up a laptop and hit the ESC key to enter forth. Type "test-all". This will test all components of the laptop.
- If there is a bad component write that the laptop is bad and the name of the bad component beside the label using a red marker and a piece of tape.
- To install the image, put the customized image (osXXX.img) and the crc file (osXXX.crc) at the root of the USB key.
- Plug in the USB key and when in forth, type "copy-nand flash u:\osXXX.img". The process will be over in a couple of minutes
SUPPORT AND MAINTENANCE
- Familiarize yourself with disassembling the laptop, replacing parts etc.
- Always carry a USB customization key with the customized image and individual activities