Path Discovery Mechanism/FWT
Jump to navigation
Jump to search
Every XO is capable of keeping up to 64 paths in its forwarding table. An entry on the forwarding table consists of the following fields.
| Entry | Meaning |
|---|---|
| DA | Destination MAC Address: the node this path entry is for. |
| RA | Receiver MAC address: the next hop for this path. |
| Valid | If the route is valid or not |
| Metric | The total cost for the path |
| Dir | Direction (1 for forward path, 0 for reverse path) |
| Rate | Data rate used to transmit to the next hop (RA) |
| SSN | Source Sequence Number (time at the RA for reverse routes. Default is 0) |
| DSN | Destination Sequence Number (time at the DA for direct routes. Default is 0) |
| Hopcount | Hop count (currently unused, default is 0) |
| TTL | Time to live, as usual in hops (Only used in reverse entries) |
| Expiration | Entry expiration (in ticks, where a tick is 1024us, or approximately 1ms. default is 0 which means never expires) |
| Sleepmode | RA's sleep mode (currently unused, default is 0) |
| SNR | SNR in the link to RA (currently unused, default is 0) |
| Precursor | Predecessor’s MAC in direct routes |
- DA or Destination address is the target for the path, while RA will be the next hop in this path. In single hop paths, i.e. paths to direct neighbors they will be the same.
- Metric will be the sum of all the costs associated to the PREQs that were successfully transmitted, hop-by-hop, from the current node to the destination (DA). Possible values for a mesh with no more than 5 hops can be seen here.
- Routes are marked invalid when MPs detect that the next hop is unreachable. Invalid routes are deleted only when FWT table is full and the XO wants to insert a new route. Note that valid routes can be expired or not expired. A time stamp is associated to every frame added to the forwarding table. This time stamp is provided by the Wireless Module and it is started every time the XO is booted. A route will be considered valid if:
Current Time <= Entry Expiration + Route Expiration Time
- The Route Expiration Time is configurable and currently defaults to 10 seconds.
- Every path has a direction (Dir). A direct (forward) path will be marked with one, reverse paths will be marked with zero in the Dir field.
- The Rate in which this node will transmit to the next hop – the RA.
- The Source Sequence Number (SSN) and the Destination Sequence Number (DSN) are used to avoid path loops.
- Hop Count is the number of hops to the destination (DA) while TTL keeps the number of hops to the Source in reverse routes.
- The field Sleepmode is currently unused, since there is currently no support to mesh power saving mode.
- The SNR value is also not used by the firmware, and is derived when the path is learned and only updated every when the path expires.
- Finally, the Precursor is the predecessor in a direct path, thus it is the one to which the node will send an Path Error frame (PERR) in case it fails to forward data frames to the next hop (RA).