XO 1.75 11089 Fix

From OLPC
Revision as of 12:50, 8 August 2011 by Wad (talk | contribs) (Any serial adapter will work, only the 1.5s need special ones...)
Jump to navigation Jump to search
  This page is monitored by the OLPC team.

Version Q4B05 of Open Firmware for the XO 1.75 B1 laptop had a bug (<trac>11089</trac>) which causes the laptops to boot up with a white screen if it has been ten days since their manufacture, or if the RTC battery is removed. The symptom is a white screen (nothing on it) on boot.

The Fix

Fortunately, the fix to this is simple (yet tedious):

  1. Turn off the laptop, unplug the power cable, but leave the battery inserted,
  2. Disassemble the laptop to access the motherboard. The heat spreader does not have to be removed.
  3. Plug in the white end of the serial cable (see below),
  4. Plug in a USB drive with Q4B06 or later,
  5. Attach the black end of the serial cable to a serial adapter,
  6. Attach the serial adapter to another computer,
  7. Plug the power cable back in, (use only the provided power adapter, not an older one),
  8. Configure a terminal emulator,
  9. Power on the laptop. It should print out a boot sequence over the serial port, which will be shown by the terminal emulator. The sequence should end in Unrecognized SPI Flash ID. It should then provide an ok prompt. If at this point, it stops somewhere else or doesn't provide a prompt (like after Releasing) you have another problem. Please contact wad.
  10. Type "dir u:" in the terminal emulator to initialize the USB stack.
  11. Type "flash u:\q4b06.rom" in the terminal emulator and the laptop will rewrite the firmware and reboot.
  12. Turn off the laptop, remove the serial cable (if it is no longer required), and reassemble.

Finding the Serial Port

You will need an XO serial adapter designed for use with XOs. The serial port to use is UART3 (CN8). There is a chart showing the location, and this photo:

1.75 serial connector.png