Kernel Building

From OLPC
Revision as of 21:32, 9 April 2007 by Walter (talk | contribs) (added categories)
Jump to navigation Jump to search


Note: it is recommended that you build an RPM (Rebuilding OLPC kernel) unless you are already familiar with kernel development!

Building an OLPC kernel

After obtaining the OLPC source (and if desired, making changes), the following steps can be taken to build a kernel on any Fedora Core 6 machine:

  • make oldconfig
  • make
  • make modules_install # as root
  • tar zcvf kern.tar.gz arch/i386/boot/bzImage System.map /lib/modules/$VERS

Replace $VERS above with the proper kernel version that has been built.

Assuming everything builds correctly, you will be left with kern.tar.gz. This can be copied over to an XO laptop, and the following steps will install the kernel (again, replacing $VERS with the kernel version):

  • cd /
  • tar zxvf .../kern.tar.gz
  • mv System.map /boot/System.map-$VERS
  • mv arch/i386/boot/bzImage /boot/vmlinuz-$VERS
  • ln -sf /boot/vmlinuz-$VERS /boot/vmlinuz

If not booting off NAND, the additional steps are also necessary:

  • mkinitrd /boot/initrd-$VERS.img $VERS
  • ln -sf /boot/initrd-$VERS.img /boot/initrd.img