Screen replacement

From OLPC
Jump to navigation Jump to search

Replacing a screen is a relatively simple task. To do this, you will need a standard #1 Phillips head screwdriver and something to hold screws in (in a pinch, parts taken off the XO can serve as temporary containers).

ScreenreplaceStep0.jpg

Taking off the front panel

Step 1

Begin by opening the laptop and flipping the screen up. Rotate it to a 90 degree angle, similar to this.

ScreenreplaceStep1a.jpg

Next, remove the screws circled in blue from the bottom of the screen. There are two on each side (right/left) of the XO, so make sure to get all four.

ScreenreplaceStep1b.jpg

Step 2

Remove the two green panels from the side of the XO by first sliding them and then lifting them off.

ScreenreplaceStep1c.jpg

ScreenreplaceStep1d.jpg

Step 3

Finally, pull off the front panel, pulling it out at the bottom and then gently sliding it downwards.

ScreenreplaceStep1e.jpg

ScreenreplaceStep1f.JPG

Taking out the screen

Step 1

To get the screen out, remove the four screws highlighted in blue.

ScreenreplaceStep2a.jpg

Step 2

Next, carefully slide the screen out, pulling the bottom out. Do not tug it or let go, as it will still be connected to the motherboard by two cables.

ScreenreplaceStep2b.jpg

Step 3

Lift up the plastic latches and gently pull out the cables. This will allow you to pull out the screen.

ScreenreplaceStep2c.jpg

ScreenreplaceStep2d.jpg

ScreenreplaceStep2e.jpg

ScreenreplaceStep2f.jpg

Replacing the screen

Step 1

Replace the screen by sliding the connection cables into place and clipping them back down (it is generally easier to clip the thinner one that has a longer tether first). Reseat the screen, making sure that it sits flat and that none of the spacers is gone.

Step 2

Replace the four screws that hold in the screen.

ScreenreplaceStep3a.jpg

Step 3

Slide the front panel back on, making sure that it sits flat. Note that there are hooks on the side of the panel (highlighted in blue) that need to slide into place; pushing the top of the screen flat and sliding it upwards works well.

ScreenreplaceStep3b.JPG

Finally, replace the green side panels and screws that were removed in the first step.