Swapping XO Man Colors

NOTE: The contents of this page are not set in stone, and are subject to change! This page is a draft in active flux ... Please leave suggestions on the talk page.

First, find someone to swap XO man colors with! You will need a standard #1 Phillips head screwdriver and something to hold screws in. (In a pinch, parts taken off the XO can serve as temporary containers) This replacement can be done within 15 minutes, even with little experience.

Before we begin

Taking off the front panel

Step 1

Open the laptop and flip the screen up. Rotate it a 90 degree angle as shown in the sequence below. Next, remove the screws from the bottom of the screen - there are two on each side (right/left) of the XO, so make sure to get all four.

Flip screen up

Rotate

Unscrew - remember, there are 4.

Step 2

Remove the two green panels from the side of the XO. Slide them upwards and lift them off as shown.

Slide up

Lift off

Step 3

Finally, pull off the front panel. It is tabbed, so it can simply be pulled out. Pull the bottom out (where the screws came out), and gently slide the piece downwards and out.

Taking out the screen

Step 1

To get the screen out, remove the four screws highlighted.

Unscrew

Step 2

Next, carefully slide the screen out, pulling the bottom out. Do not tug it or let go, as it will still be connected to the motherboard by two cables.

Slide out gently

Watch out for cables!

Unhook the cable

Watch out for this little cable, too.

Good to go!

Removing the XO Man

Step 1

Keep the screen out of the way until the replacement is complete.

Take out 4 screws

Turn over. Pull up and remove the back plate

Replacing the XO Man

Step 1

Turn the back plate over. Note where the colored plastic fits in.

Use a screwdriver to pop these out

Turn plate over so the XO man faces you. Pull the plastic part out.

Step 2

Turn over. Replace the back plate.

Pick the right screw!

Turn over. Secure the back plate by putting in the four screws where indicated.

Replacing the screen

Step 1

Replace the screen by sliding the connection cables into place and clipping them back down (it is generally easier to clip the thinner one that has a longer tether first). Reseat the screen, making sure that it sits flat and that none of the spacers are gone.

Error creating thumbnail: File missing

Clip little cable in

Clip big cable in

Gently slide screen back in

The screws with the large heads (4) go back in

Step 2

Slide the front panel back on, making sure that it sits flat. Note that there are hooks on the side of the panel (highlighted in blue) that need to slide into place; pushing the top of the screen flat and sliding it upwards works well.

Watch out for these hooks

The rest of the panel slides into place

Step 3

Slide the green side pieces back into place. Then, rotate the XO 90 degrees and put the remaining screws back. Don't forget that the screws go in on both sides (right/left).

Side panels slide back in place

Almost there!

Rotate

Put screws (4) back in.

And you're done! Yay! :D