OLPC Firmware Q2A62
Jump to navigation
Jump to search
This page is monitored by the OLPC team.
OLPC Firmware Production Release Q2A62 - 2006-12-11
This is the update release for the B-test build.
Not uploaded yet. Awaiting testing
MD5
Changes since Q2A54
- EC: update to A62
- EC: Dead battery charging fix
- EC: Add battery charging indicator LED
- OFW: Update to SVN 55
- OFW: Improve performance by preallocating some DMA resources.
- OFW: Support USB storage devices that identify themselves as "removable"
instead of "scsi"
- OFW: Support FAT filesystem on devices with sector sizes other than 512.
Installation Caveats
- After you reflash, you must power cycle by physically removing power from the system. A warm-start or button-induced restart is not sufficient. Please remove both the battery pack and wall adapter for 10 seconds.
ATest users only: If you use olpcflash to write this image, you must use the --brick option.
Example: olpcflash --brick -w image.rom
This will update your EC code.
BTest-1 users should NOT use olpcflash to write new firmware images. Doing so will erase the manufacturing data that was added at the factory.
Known issues
- Auto-repeat is slow on some USB keyboards
- NVRAM storage for configuration variables is not yet implemented.
- JFFS2 does not pay attention to the bad block table.
- JFFS2 does not handle ECC
- The boot menu is incomplete
- Dirctory symlinks have a problem.
ATest -- Infineon RAMs only
Thise is a special purpose image. Do not use except on A-test boards with Infineon RAMS.
For more info see Upgrading_to_LinuxBIOS#Checking_your_DRAM_type
MD5: