OLPC Firmware q2c23

From OLPC
Revision as of 18:05, 6 October 2012 by FGrose (talk | contribs) (Proper name for Open Firmware)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigation Jump to search

OLPC Firmware Release q2c23 - 2007-08-10

This firmware is what actually went into the CTest build. It works well on B3 and later systems. Do not use it on pre-B1 boards - it will brick them because of the EC microcode.

Support for ATest has been removed!.

BIG FAT WARNING! The manufacturing data has moved locations. If you are upgrading from the B series of the firmware the manufacturing data will be moved to its new location. After that has happened you must not install anything from the B series of the firmware. If you do then you will erase your manufacturing data.


Download: q2c23


How to get the ok prompt

Power & Game buttons

Press the "X" (down) game key after hitting the power button to enable the ok prompt. You still have to press the ESC key (upper left on the keyboard Key esc.jpg) during the countdown. If you don't press the "X" game key, the firmware goes into fastboot mode, in which:

  • The keyboard is not probed, thus saving some time
  • The boot order is USB, SD, NAND, wireless
  • OFW does not put any text on the screen, just graphics

In some previous firmware versions, pressing any game key would get you to interactive mode; in this version, only the "X" game key, which is the one nearest to the power button, does so.

Changes since OLPC Firmware q2c22

Open Firmware is r533

  • Made scrolling 20x faster by using the graphics processor
  • Fixed "Can't assign address ranges larger than 32-bits" problem
  • Improved "watch-battery" output
  • Support the "writing" command from the Forthmacs file system interface wordset (alternative to $create-file)
  • Fixed a display glitch with "insert-characters" and "delete-characters" in the terminal emulator

EC code is PQ2C23

Changes from PQ2C22

  • Fix for "The EC doesn't detect battery after plug-in/out battery several times on hardware 1-wire."
  • Fix for "It still continue to hold the SOC at 84% after V85 was reached (on NiMH battery)."

Installation Instructions

  • If you have a B1-B4 system:
    • Detailed upgrade instructions are located here.
    • If your firmware version is earlier than the version in Auto Install Image then you can just use that procedure for the update.
      Note: that this procedure will also upgrade the image in your nand flash -- which is the entire Linux operating system and all the files you may have edited or saved. This means it will ERASE what is in your nand and re-write it. So you will lose any data you have stored on the filesystem unless you back it up. If you do not want your files erased, then please use the first procedure above.
    • Do NOT use olpcflash to write new firmware images. Doing so will erase the manufacturing data that was added at the factory.
    • After you reflash, you must power cycle by physically removing power from the system. A warm-start or button-induced restart is not sufficient. Please remove both the battery pack and wall adapter for 10 seconds.
  • If you have an ATest system
    • Don't use this firmware. ATest support has been removed.