Oprofile setup

From OLPC
Revision as of 18:33, 8 January 2008 by 69.59.76.78 (talk)
Jump to navigation Jump to search
  english | spanish HowTo [ID# 93721]  +/-  


Setting Up OProfile to Run on OLPC Laptop

It is possible to get OProfile in timer mode working on the olpc machine. Performance monitoring hardware on Geode process is not supported. The jffs2 file system does NOT support the mechanism that OProfile uses. You will need another file system such as ramfs filesystem or USB flash drive formatted as ext3 or VFAT to store the OProfile data.

OLPC Machine Steps

  • 1) Install binutils and oprofile:
yum install binutils oprofile
  • 2) If running from an image in the internal jffs2 file system,

you will need to mount another file system to store the samples. Below are examples of the commands to set that up. You will need to modify for local conditions.

mount -t ramfs none /var/lib/oprofile

Or

mkdir /media/usbflash
mount -t ext3 /dev/sda1 /media/usbflash
rm -rf /var/lib/oprofile/samples/current
mkdir /media/usbflash/samples
ln -s /media/usbflash/samples /var/lib/oprofile/samples/current
  • 3) As root configure OProfile to collect data:
opcontrol --setup --vmlinux=/root/vmlinux --separate=library

If you do not care about kernel data, you can skip installing vmlinux and configure with:

opcontrol --setup --no-vmlinux --separate=library
  • 4) As root start oprofile running with:
opcontrol --start
  • 5) Do desired experiment to collect data
  • 6) As root shutdown OProfile with:
opcontrol --shutdown
  • 7) Look at the data with the "opreport" command.
  • 8) Unmount filesystem storing OProfile samples if needed.