Screen replacement: Difference between revisions
Jump to navigation
Jump to search
m (redundant with Disassembly top - redirected as per Wad's request) |
|||
| (49 intermediate revisions by 4 users not shown) | |||
| Line 1: | Line 1: | ||
#REDIRECT [[Disassembly top#Removing the screen]] |
|||
{{TOCright}} |
|||
Replacing a screen is a relatively uncomplicated task. To do this, you will need a standard #1 screwdriver and something to hold screws in (in a pinch, parts taken off the XO can serve as temporary screw holders). |
|||
[[image:ScreenreplaceStep0.jpg]] |
|||
== Taking off the front panel == |
|||
[[Image:ScreenreplaceStep1a.jpg]] |
|||
Begin by opening the laptop and flipping the screen up, and then rotating it to a 90 degree angle, similar to [[:Image:DSCN0305.jpg|this]]. |
|||
[[Image:ScreenreplaceStep1b.jpg]] |
|||
Next, remove the screws circled in blue from the bottom of the screen. There are two on each side (right/left) of the XO, so make sure to get all four. |
|||
[[Image:ScreenreplaceStep1c.jpg]] |
|||
[[Image:ScreenreplaceStep1d.jpg]] |
|||
Remove the two green panels from the side of the XO by first sliding them and then lifting them off. |
|||
[[Image:ScreenreplaceStep1e.jpg]] |
|||
[[Image:ScreenreplaceStep1f.JPG]] |
|||
Finally, pull off the front panel, pulling it out at the bottom and then gently sliding it downwards. |
|||
== Taking out the screen == |
|||
Latest revision as of 17:04, 27 June 2008
Redirect to: