Repair Manual: Difference between revisions

From OLPC
Jump to navigation Jump to search
(→‎Disassembly and reassembly: Partial procedure)
(Redirected page to Repair)
 
(10 intermediate revisions by 8 users not shown)
Line 1: Line 1:
#REDIRECT [[Repair]]
See Roy Doty's [http://www.roydoty.com/syndicated/wordless-panel.htm Wordless Workshop] for the right way to do this, so it doesn't need translating.


<!-- This page was a stub that never fleshed out, and has confused a few people. Redirect to Repair which covers Disassembly too. -->
==XO design requirements and test data==
*Drop tests
*Heat tests
*Liquids
*Dust and sand
*Electrical
*Safety

==[[Open Firmware]] diagnostics==


==Disassembly and reassembly==

Tools: #1 Phillips screwdriver

#Make sure XO is unplugged.
*(pic: XO closed, no power plugged in)
#Remove battery
*(pic: slide battery clips to the sides)
*(pic: battery removed)
#Open computer to upright position
*(pic: antennae raised)
*(pic: body opened to upright position)
#Turn screen sideways
*(pic: screen turned to allow access to screws)
#Remove two screws on bottom of body.
*(pic: Show two screws per side)
*#Turn screen the other way and remove two screws.
*(pic: Screws removed and put into container)
#Remove side covers.
*(pic: two covers, a loose piece under one of them (what is it?), and bared side of XO)
#Slide screen bezel down and remove.
*(pic: bezel moved)
*(pic: bezel removed)
#Remove loose griefpad.
*(pic: griefpad location and griefpad)
#Remove four large screws holding screen
*(pic: Screen and screws)
*(pic: Screen removed)
*(pic: )
*(pic: )
*(pic: )
*(pic: )
*(pic: )
*(pic: )
*(pic: )
*(pic: )
*(pic: )
*(pic: )

==Frankenputers==


==Battery life==


==Recycling==

Latest revision as of 13:49, 19 May 2010

Redirect to: