XO1.75 A2 A3 Changes: Difference between revisions
Jump to navigation
Jump to search
(Created page with 'These are the changes planned for the XO-1.75 B1 prototype, from the A2 prototypes. =A2 Electrical Fixes= These changes fix problems in the A2 prototypes: ==SD p…') |
(→eMMC) |
||
| Line 19: | Line 19: | ||
==eMMC== |
==eMMC== |
||
This adds a needed pullup to the eMMC CMD signal. |
|||
* Populate R95 with |
* Populate R95 with 10K. |
||
* Connect BOOT_DEV_SEL to CN21.10 |
|||
* Use +3.3V_SD1 to power the eMMC instead of +3.3V_NAND |
|||
=A2 Layout Fixes= |
=A2 Layout Fixes= |
||
Revision as of 06:55, 9 January 2011
These are the changes planned for the XO-1.75 B1 prototype, from the A2 prototypes.
A2 Electrical Fixes
These changes fix problems in the A2 prototypes:
SD power
These correct a mistake in Embedded Controller pin assignments for the SD power control signals.
- Depopulate R335 and R345.
- Remove Q16, and short pins 2 and 3 (marked I and O).
- Remove Q16, and short pins 2 and 3 (marked I and O).
VMEM stability
This corrects an undercompensation of the +1.5V memory power supply, and also delays the turn-on of the memory termination power supply.
- Change PR49 to 22K.
- Change PR52 to 47K.
- Populate PC37 with 0.1 uF.
eMMC
- Populate R95 with 10K.
- Connect BOOT_DEV_SEL to CN21.10
- Use +3.3V_SD1 to power the eMMC instead of +3.3V_NAND