XO1.75 A2 A3 Changes: Difference between revisions
Jump to navigation
Jump to search
m (style) |
|||
| Line 29: | Line 29: | ||
The MISO and MOSI pins on J2 are swapped (the SOC GPIO map was wrong). |
The MISO and MOSI pins on J2 are swapped (the SOC GPIO map was wrong). |
||
SPI_MISO should be connected to U10.2, J2.1, and U11.AD15 (GPIO43) |
*SPI_MISO should be connected to U10.2, J2.1, and U11.AD15 (GPIO43) |
||
| ⚫ | |||
| ⚫ | |||
=A2 Layout Fixes= |
=A2 Layout Fixes= |
||
Revision as of 22:38, 14 April 2011
These are the changes planned for the XO-1.75 B1 prototype, from the A2 prototypes.
A2 Electrical Fixes
These changes fix problems in the A2 prototypes:
SD power
These correct a mistake in Embedded Controller pin assignments for the SD power control signals.
- Depopulate R335 and R345.
- Remove Q16, and short pins 2 and 3 (marked I and O).
- Remove Q16, and short pins 2 and 3 (marked I and O).
- Q16 mentioned twice here, perhaps you mean Q21? --Quozl 22:34, 14 April 2011 (UTC)
VMEM stability
This corrects an undercompensation of the +1.5V memory power supply, and also delays the turn-on of the memory termination power supply.
- Change PR49 to 22K.
- Change PR52 to 47K.
- Populate PC37 with 0.1 uF.
eMMC
- Populate R95 with 10K.
- Connect BOOT_DEV_SEL to CN21.10
- Use +3.3V_SD1 to power the eMMC instead of +3.3V_NAND
J2
The MISO and MOSI pins on J2 are swapped (the SOC GPIO map was wrong).
- SPI_MISO should be connected to U10.2, J2.1, and U11.AD15 (GPIO43)
- SPI_MOSI should be connected to U10.5 , J2.4, and U11.AE15 (GPIO44)
A2 Layout Fixes
- Bring GPIO04 (pin 5) to a user-probeable pad, for brick recovery purposes. (It may need to be grounded during EC flash reprogram.)