OLPC Firmware Q2B15: Difference between revisions
Jump to navigation
Jump to search
(Q2B15) |
m (categorization) |
||
Line 38: | Line 38: | ||
'''The ATest/Infineon RAMS variant of this firmware version has not been released.''' |
'''The ATest/Infineon RAMS variant of this firmware version has not been released.''' |
||
[[Category:Firmware]] |
Latest revision as of 06:11, 13 January 2007
This page is monitored by the OLPC team.
OLPC Firmware Pre-Production Release Q2B15 - 2007-01-02
This is the firmware for the pre-production test build of the B2 boards.
MD5: 0a1e413f0801d1fa1a1cd3ca402c736a
Changes since Q2B14
- LinuxBios: The 33/66 MHz switching code was accidentally omitted in B13 and B14, and has been reinstated in B15.
Installation Caveats
- If you have a B1 system:
- Perform the auto-reinstall procedure at http://wiki.laptop.org/go/Autoreinstallation_image before upgrading to this firmware version
- DO NOT use olpcflash to write new firmware images. Doing so will erase the manufacturing data that was added at the factory.
- After you reflash, you must power cycle by physically removing power from the system. A warm-start or button-induced restart is not sufficient. Please remove both the battery pack and wall adapter for 10 seconds.
ATest users only: If you use olpcflash to write this image, you must use the --brick option.
Example: olpcflash --brick -w image.rom
This will update your EC code.
Known issues
- Auto-repeat is slow on some USB keyboards
- NVRAM storage for configuration variables is not yet implemented.
- JFFS2 does not handle ECC
- The boot menu is incomplete
- Dirctory symlinks have a problem.
The ATest/Infineon RAMS variant of this firmware version has not been released.