Creating a testbed: Difference between revisions
Jump to navigation
Jump to search
m (created stub) |
(No difference)
|
Latest revision as of 19:40, 12 August 2008
This article is a stub. You can help the OLPC project by expanding it.
![]() |
NOTE: The contents of this page are not set in stone, and are subject to change! This page is a draft in active flux ... |
![]() |
This page is intended to walk people through creating an XO testbed for hardware/software testing. It is incomplete- please add your notes and ideas. Mchua
Set up
- Get a power strip and plug all your XOs in.
- Set up your XOs on a table/counter/shelf. Make sure all the screens are visible, and (if applicable) the keyboards are accessible.
- Prepare an Activated upgrade USB key(s) for the software (firmware, build, and Activities) you're testing. Systematically reflash every XO and verify the software version.
Tools
In this section should go descriptions of all the testing/logging scripts on the XO.
Test
- Perform the test as documented.
Report
Follow the instructions on Testing and Friends in Testing for reporting results, logs, and bugs you found.