OLPC Firmware Q2A42: Difference between revisions
Jump to navigation
Jump to search
m (categorization) |
(FIELD_OTHER) |
||
| Line 14: | Line 14: | ||
* After you reflash, you must power cycle by physically removing power from the system. A warm-start or button-induced restart is not sufficient. |
* After you reflash, you must power cycle by physically removing power from the system. A warm-start or button-induced restart is not sufficient. |
||
FIELD_MESSAGE_c4tchiouv |
|||
=== Known issues === |
|||
* Some USB keyboards don't work behind a hub. |
|||
* At least one USB keyboard dosen't work at all |
|||
* Auto-repeat is slow on some USB keyboards |
|||
* NVRAM storage for configuration variables is not yet implemented. |
|||
* JFFS2 does not pay attention to the bad block table. |
|||
* JFFS2 does not handle ECC |
|||
* The boot menu is incomplete |
|||
* Network drivers are not present |
|||
* The new recipe for poweroff (using ACPI register PM1_CNT to ask SB to turn off main_on&sus_on) is not yet implemented. |
|||
* Dirctory symlinks have a problem. |
|||
[[Category:Firmware]] |
|||
Revision as of 22:09, 16 December 2008
This page is monitored by the OLPC team.
OLPC Firmware Production Release Q2A42 - 2006-11-12
This is the production release for the B-test build.
MD5 2f7a1bb56ed76e5b3274bab37c239fed olpc-Q2A42.rom
Installation Caveats
- If you use olpcflash to write this image, you must use the --brick option.
- After you reflash, you must power cycle by physically removing power from the system. A warm-start or button-induced restart is not sufficient.
FIELD_MESSAGE_c4tchiouv