Screws
Jump to navigation
Jump to search
This page is monitored by the OLPC team.
These are the screws used in the XO laptop, and their locations. This is part of the Disassembly and Repair guides.
From left to right:
- (A) M2x.4 x 4mm - the common blackened ones. There are a lot of these - use anywhere a specific type of screw is not specified.
- (B) M3x.45 x 5mm - There are 4 of them. These attach the hinge to the bottom half of the laptop. (This is a non-standard pitch for this diameter.)
- (C) M2x.4 x 6mm - the long shiny ones. There are 6 of them. Four are used to attach the back cover (over the motherboard). Two are used to hold the hinge cover together, one on each side.
- (D) M2x.4 x 2mm - the short shiny ones. There are 4 of them. 2 of these hold the keyboard controller circuit board in place, the other two help screw the keyboard to the keyboard bezel. Holes for these screws are marked with this symbol:
.
Not shown:
- fat M2x.4 x 7.62mm (0.3in) - the screen screws. These are cushioned by 4 black rubber ring bumpers and hold the screen in place.
- M2.5x.45 x 12.7mm (0.5in) - The antenna ear screws. Four of these hold the antenna ear clamps in place.
The screws are metric (ISO). The number immediately after the M is the rough diameter (in mm), followed by the pitch (in mm) after the first 'x'. The length is indicated after the second 'x'. Two of our screws have a precise length in english units, but not metric units.