Wireless access point compatibility
Jump to navigation
Jump to search
This page provides a listing of routers that have been tested for compatibility with the XO Laptop.
| Manufacturer | Model | Firmware | Tested | Build | Notes |
|---|---|---|---|---|---|
| 2Wire | 2700HG-B GATEWAY | 4.25.19 | Unsecured | Didn't work / couldn't find on channel 4. Changed to channel 5 and XO found it and connected just fine. Unsecured network. | |
| 2Wire | 2701HG-B GATEWAY | 5.29.47 | Yes | Had to change the internet mode from the default of 802.11b/g to 802.11g | |
| 2Wire | 3800HGV-B Gateway | 5.29.105.76 | Yes | ATT Uverse supplied, changed WPA to WEP-open and assigned to channel 8 as opposed to Automatic | |
| Actiontec | MI424WR | Unknown | Yes | WPA non-functional on update.1 | |
| Airlink 101 | AR525W | v1.0.50 | Yes | Used WEP-Open with 128-bit hex key password | |
| Apple | AirPort Express | 6.3 | Yes | For WEP provide and select: ASCII + Shared key | |
| Cisco | AIR-BR1310G-A-K9-R | 12.3(8)JA | Unsecured Only | Works but radio must be set to channels 1, 6, or 11. I normally configure this device to automatically choose the least congested frequency, but in my office that ends up being something other than 1, 6 and 11 most of the time. Note also that activity sharing totally fails with this AP - nada, zip. | |
| Conceptronic | C54BRS4A | 1.00 | Yes | Joyride 2263 - Firmware Q2E12 | Worked for WEP open with ASCII password. |
| D-Link | DIR-615 | 2.20 | Yes | worked with WPA2 (personal) and the Wpa.sh script | |
| D-Link | DWL-G730AP | 2.00 | Yes | Worked with WEP 128 as an access point. | |
| D-Link | DWL2100AP | unknown | In field only | This AP was tested and may be used in Nepal. It was also tested for Australia/Pacific Islands where it was unsuccessful and unable to allocate DHCP addresses. | |
| D-Link | DWL2200P | unknown | In field only | This AP was tested and may be used in Nepal | |
| D-Link | DWL3200P | unknown | In field only | This AP was tested and may be used in Nepal
| |
| D-Link | D-Link WBR-2310 | 1.02 | Yes | Open/WEP/WPA2 working. WPA fails, see: <trac>7825</trac> | |
| FON | La Fonera 2100E | Release: 0.7.1.2 | Yes | Security: WEP, Type: Open System, 64-bit key password | |
| Linksys | WAG54G V2 | 1.01.22 | Yes | Tested with no security; also with WAP | |
| Linksys | BEFW11 S4 version 2 | 1.45.10 | Yes | 650, 708, 2230 | Tested with WEP 128-bit key. A few times with build 708 I had to return to Neighborhood View to reconnect after standby, and once I had to re-enter the hex key. |
| Linksys | WCG200-CC | Yes | Tested with no security; also with WEP 128 passphrase. See Sharing_User_Experiences_with_OLPC_XO_Wifi_Connectivity_-_Glew_2007_Jan for trick. | ||
| Linksys | WRT54G | 4.21.1 1/20/2007 | Yes | Use channel 1, 6, or 11 (see Wifi_Connectivity#Channel). | |
| Linksys | WRT54G V4 | DD-WRT v23 SP2 micro | Yes | WEP connects fine all channels, WPA2 via wpa.sh script. | |
| Linksys | WRT54GL | OpenWRT WhiteRussian (RC4) | Yes | tested using no security (MAC based access control) on channel 3
| |
| Linksys | WRT54GL | OpenWRT Kamikaze 7.09~ | Yes | WPA works. | |
| Linksys | WRT54GL | v4.30.11, Aug. 7, 2007 | Yes | WPA2 via Wpa.sh, G-only on channel 6 | |
| Linksys | WRT300Nv1.1 | 1.51.2 6/04/2007 | Yes | WPA2 via Wpa.sh, G-only on channel 11 | |
| Linksys | WRT350N | Yes | WPA | ||
| Linksys | WRT350N | 1.03.7 | Unsecured | Cannot connect using no security. | |
| Linksys | WRT600N | 1.01.36 build 3 | Unsecured | 703, 708, joyride-2230 | Can connect with no security (I use MAC filtering) |
| Microsoft | MN-700 | 02.01.02.0590 | Yes | Connects only when base station wireless security encryption is set to "none". Tried unsuccessfully to connect with WEP, and then with WPA enabled (G1G1 build 656). The only
wireless security setting that works with this router and OLPC is Mac filtering. | |
| NETGEAR | WGR614v6 | V2.0.14_1.0.14 | Yes | joyride-2230 / firmware Q2E12 | Works alright with WPA encryption. |
| NETGEAR | WGT624v3 | ? | "Tested"?? | B4, joyride 1597, q2d10. The following settings worked (some others did not). On the router: Name: lettersonly, Channel: 11, Mode: g only, Security Options: WEP, Authentication type: Shared key, Encryption Strength: 128bit, Key 1. On the XO: Key Type: Hex, key: <the same as router Key 1>, Authentication Type: Shared Key.
B4 image 703. Hardware Version: V3H1 Firmware Version: V2.0.10_1.0.1NA. WEP worked only in Open System Mode. WPA worked in both TKIP, AES and auto modes. | |
| NETGEAR | WPN824v2 | V2.0.10_1.2.17 | Yes | G1G1 Tested WEP 128-bit PSK with 1.2.17 firmware (XO builds 650, 653), WPA2 CCMP PSK with 2.0.10 firmware (on build joyride-1500). Saw occasional failures to connect. When switching from WEP to WPA2, had to wipe out /home/olpc/.sugar/default/nm/networks.cfg, use the Wpa.sh script, and reboot. Working fine now. | |
| Siemens | Gigaset SE567 | 004-E652-A3D-115-36-13 | WPA-PSK | Joyride-2301 Firmware q2e13 | Security: WPA-PSK+TKIm Channel: 6 Mode: mixed b/g
|
| ST-585 | SpeedTouch 585[i]V6 | V6.2.15.5 | Yes | Works with WEP(open/hidden, 128-bit shared key) | |
| TP-LINK | TL-WA501G | v2.0.0 | Yes | Works with WEP(open, 128-bit shared key)in all channels | |
| TRENDnet | TEW432BRP_c1 | v2.00.0012 | WEP | Does not show up in neighborhood until you attempt to connect to another WAP (e.g. at a neighbors house). The Trendnet then immediately shows up, and you can connect to it instead. Is on channel 9, maybe 1,6,11 would work better. | |
| Westell | D90-327W15-06 | VER:4.03.02.04 | Yes | Security: WEP, Type: Open System, 128-bit key password (13 characters) | |
| Zyxel | P-660HW-D1 | Version: V3.40(AGL.4) | Yes | No security | |
| Westell | VersaLink Gateway Model 327W15-06 | Unknown | Yes | 708 | Security: WEP, Type: Open System / Shared Key, 128-bit key password (13 characters) |
| Linksys | WRT54GS V1.1 | Tomato Firmware v1.19.1463 (http://www.polarcloud.com/tomato) | Yes | 708 | Security: WPA-PSK+TKIP, Mode: mixed b/g, Channel 11, XO S/N SHF80800F63 |
| SAGEM[1] | F@st 1500WG | 2.3.14.0 | Yes | Joyride-2301 Firmware q2e12 | WEP, Hex 40/128, channel 11, Mixed 11 b/g.S/N SHF80701C99. Is communicating with the modem continuously (keeps sending in msh0 alternating 2 and 4b packets when no web applications are running) and eventually is resetting the modem. |
| Manufacturer | Model | Firmware | XO Build | XO serial number | Tester contact info | Notes |
|---|---|---|---|---|---|---|
| SMC | Barracuda | V1.06 | 650, 656 (1 XO) and 703 (2 XOs) | CSN749022A0 | Culseg | limited to 40 or 128 WEP but works reliably. http://www.smc.com/index.cfm?event=support&localeCode=EN_USA |
| Zoltan Tech | ZoWii | joyride 2301 | CSN74803DDB | AuntiMame | Works fine. Not wireless -- but I didn't know where else to report this. |