Repair Manual
See Roy Doty's Wordless Workshop for the right way to do this, so it doesn't need translating.
Contents
XO design requirements and test data
- Drop tests
- Heat tests
- Liquids
- Dust and sand
- Electrical
- Safety
Open Firmware diagnostics
Disassembly and reassembly
Tools:
- 1 Phillips screwdriver
- 3/8"? open end wrench or needle-nose pliers
- Make sure XO is unplugged.
- (pic: XO closed, no power plugged in)
- Remove battery
- (pic: slide battery clips to the sides)
- (pic: battery removed)
- Open computer to upright position
- (pic: antennae raised)
- (pic: body opened to upright position)
- Turn screen sideways
- (pic: screen turned to allow access to screws)
- Remove two screws on bottom of body.
- (pic: Show two screws per side)
- Turn screen the other way and remove two screws.
- (pic: Screws removed and put into container)
- Remove side covers.
- (pic: two covers, a loose piece under one of them (what is it?), and bared side of XO)
- Slide screen bezel down and remove.
- (pic: bezel moved)
- (pic: bezel removed)
- Remove loose griefpad.
- (pic: griefpad location and griefpad)
- Remove four large screws holding screen
- (pic: Screen and screws)
- Slide screen down to reveal two ribbon cable connecters
- (pic: Screen moved, ribbon cables connected)
- Using pull tab provided, disconnect screen from small connector.
- (pic: Cable disconnected)
- Turn large connector cover up, and with provided pull tab, remove connector.
- (pic: Second cable removed)
- Remove screen
- (pic: XO without screen)
- Remove four screws holding hinge to base
- (pic: hinge support)
- (pic: top section separated from base)
- (pic: )
- (pic: )
- (pic: )
- (pic: )
- (pic: )