Repair Manual

It has been suggested that this article or section be merged with Repair. (Discuss)

This page is a work in progress. Please see Disassembly for how to take apart your XO.

See Roy Doty's Wordless Workshop for the right way to do this, so it doesn't need translating.

XO design requirements and test data

• Drop tests
• Heat tests
• Liquids
• Dust and sand
• Electrical
• Safety

Open Firmware diagnostics

See XO-1 OFW Self Test Diagnostics

Disassembly and reassembly

Tools:

• \#1 Phillips screwdriver
• 3/8"? 8mm? open end wrench or needle-nose pliers

1. Make sure XO is unplugged.

• (pic: XO closed, no power plugged in)

1. Remove battery

• (pic: slide battery clips to the sides)
• (pic: battery removed)

1. Open computer to upright position

• (pic: antennae raised)
• (pic: body opened to upright position)

1. Turn screen sideways

• (pic: screen turned to allow access to screws)

1. Remove two screws on bottom of body.

• (pic: Show two screws per side)
  1. Turn screen the other way and remove two screws.
• (pic: Screws removed and put into container)

1. Remove side covers.

• (pic: two covers, a loose piece under one of them (what is it?), and bared side of XO)

1. Slide screen bezel down and remove.

• (pic: bezel moved)
• (pic: bezel removed)

1. Remove loose griefpad.

• (pic: griefpad location and griefpad)

1. Remove four large screws holding screen

• (pic: Screen and screws)
• Slide screen down to reveal two ribbon cable connecters
• (pic: Screen moved, ribbon cables connected)
• Using pull tab provided, disconnect screen from small connector.
• (pic: Cable disconnected)
• Turn large connector cover up, and with provided pull tab, remove connector.
• (pic: Second cable removed)
• Remove screen
• (pic: XO without screen)
• Remove four screws holding hinge to base
• (pic: hinge support)
• (pic: top section separated from base)

1. Remove screws on main board cover

• (pic: Cover slid down)
• (pic: Main board uncovered)

1. Remove screws on metal plate on main board

• (pic: Board and plate)

1. Remove screws on main board

• (pic: Main board slid out)

1. Unscrew and remove green plastic bits on keyboard assembly

• (pic: )
• (pic: )
• (pic: )
• (pic: )

1. Remove back of keyboard

• (pic: )

1. Disconnect keyboard

• (pic: Keyboard slid out)
• (pic: Keyboard removed)
• (pic: )
• (pic: )
• (pic: )
• (pic: )
• (pic: )
• (pic: )
• (pic: )
• (pic: )
• (pic: )
• (pic: )
• (pic: )
• (pic: )
• (pic: )
• (pic: )
• (pic: )

To reassemble, just reverse the procedure above.