ProtoSnap Contributors Guide
This ProtoSnap Contributors/Testers Guide uses TurtleArt initially, but later Scratch & Etoys are expected. Ask questions on the unleashkids@googlegroups.com mailing list here: http://groups.google.com/group/unleashkids
These instructions have been tested on the XO-4 Touch laptop, and should run on XO-1, XO-1.5, XO-1.75 too. But Ian Daniher will investigate whether "ino" below can be made to run on OLPC Release 11.3.1 (based on Fedora 14) commonly used in Haiti.
Loosely speaking, this 5-phase install will proceed as follows:
- install requirement
- setup build environment
- build it
- upload it (to the SparkFun board)
- install the TurtleArt plugin
Now down to business
- install http://wiki.laptop.org/go/Release_notes/13.2.0#XO-4
- connect to Wifi Internet (Neighborhood View = F1 key)
- open Terminal Activity (Sugar's list view in the top-right)
- 3 packages you need, each take several min to install. Run:
sudo yum install ino sudo yum install git (type "y" when asked if importing GPG key is OK) sudo yum install make
- run the following 4 commands:
mkdir firmata cd firmata ino init mkdir lib
- correct packaging error in ino, running these 4 commands:
sudo mkdir /usr/share/arduino/hardware/tools sudo cp /etc/avrdude/avrdude.conf /usr/share/arduino/hardware/tools cp /usr/share/arduino/libraries/Firmata/examples/StandardFirmata/StandardFirmata.ino ./src/sketch.ino ino build
- plug in USB-A to mini-USB cable attached to ProtoSnap (Ian can provide, or 80 cents @ monoprice.com). Then run:
ino upload
- Then ProtoSnap's bright white light will turn on! Run:
git clone https://github.com/itdaniher/turtleblocks-arduino.git ~/Arduino/TurtleBlocks.activity/plugins/arduino
- Return to Sugar's Activity wheel (Home View) and launch the TurtleArt Activity. Load the sample TurtleArt project here:
http://wiki.laptop.org/go/File:TurtleBlocks_Activity.ta
- Go wild in TurtleArt, submitting priority bug reports to our mailing list unleashkids@googlegroups.com (http://groups.google.com/group/unleashkids)
