Repair Manual

From OLPC
Revision as of 16:45, 2 December 2007 by Mokurai (talk | contribs) (Disassembly and reassembly: Partial procedure)
Jump to: navigation, search

See Roy Doty's Wordless Workshop for the right way to do this, so it doesn't need translating.

XO design requirements and test data

  • Drop tests
  • Heat tests
  • Liquids
  • Dust and sand
  • Electrical
  • Safety

Open Firmware diagnostics

Disassembly and reassembly

Tools: #1 Phillips screwdriver

  1. Make sure XO is unplugged.
  • (pic: XO closed, no power plugged in)
  1. Remove battery
  • (pic: slide battery clips to the sides)
  • (pic: battery removed)
  1. Open computer to upright position
  • (pic: antennae raised)
  • (pic: body opened to upright position)
  1. Turn screen sideways
  • (pic: screen turned to allow access to screws)
  1. Remove two screws on bottom of body.
  • (pic: Show two screws per side)
    1. Turn screen the other way and remove two screws.
  • (pic: Screws removed and put into container)
  1. Remove side covers.
  • (pic: two covers, a loose piece under one of them (what is it?), and bared side of XO)
  1. Slide screen bezel down and remove.
  • (pic: bezel moved)
  • (pic: bezel removed)
  1. Remove loose griefpad.
  • (pic: griefpad location and griefpad)
  1. Remove four large screws holding screen
  • (pic: Screen and screws)
  • (pic: Screen removed)
  • (pic: )
  • (pic: )
  • (pic: )
  • (pic: )
  • (pic: )
  • (pic: )
  • (pic: )
  • (pic: )
  • (pic: )
  • (pic: )

Frankenputers

Battery life

Recycling