Talk:Projects/WaterPurifier: Difference between revisions
m (Created page with '= UV Light Water Purifier Discussion = == Point 1 == == Point 2 ==') |
mNo edit summary |
||
| Line 1: | Line 1: | ||
= UV Light Water Purifier Discussion = |
= UV Light Water Purifier Discussion = |
||
== |
== OLPC Category == |
||
* http://wiki.laptop.org/go/Water_and_sanitation |
|||
== Point 2 == |
|||
== OLPC Responses == |
|||
=== Nathan Riddle === |
|||
The maximum output of the USB port is 1 amp (5 watts at 5 volts). |
|||
The maximum output of the power module is 1.42 amps (about 16 watts at |
|||
12 volts). |
|||
Water purifiers are roughly 5 watts for one gallon per minute. If you |
|||
are just purifying a glass of water, units are available that use a |
|||
couple of AA batteries (3.5 volts). |
|||
A UV lamp is a fluorescent lamp with a quartz "glass" (in case of high |
|||
efficiency models) and as such is a high voltage discharge tube. Some |
|||
type of transformer (ballast) is needed to step up the volage to operate |
|||
the lamp -- these are separate modules or may be built into the lamp |
|||
base as in the case of compact fluorescent lamps. Voltages are about |
|||
150 volts or higher to start the discharge and may drop to 90 volts for |
|||
operation. |
|||
Wires held with tension (clips) can be substituted for sockets (or |
|||
electrical tape, for example, or wires glued against the contacts). |
|||
In the hobby market there are six inch fluorescent lamps. These are |
|||
operated by 6 volt or 12 volt lantern batteries using a small (1" |
|||
square) circuit board and draw less than 1/2 amp. |
|||
Now, if Christian can supply the description of the lamp purchased from |
|||
Amazon, maybe a ballast can be found to operate from the 12 volt power |
|||
supply used for the XO (or maybe from the USB port for low amounts of |
|||
water). The ideal is to just buy a water purification arrangement that |
|||
has a ballast that is powered by 5 or 12 volts. |
|||
Corbin bought: http://www.amazon.com/gp/product/B0027ND0VO - [[User:christianabryant|Christian Bryant]] |
|||
Revision as of 07:14, 6 July 2011
UV Light Water Purifier Discussion
OLPC Category
OLPC Responses
Nathan Riddle
The maximum output of the USB port is 1 amp (5 watts at 5 volts). The maximum output of the power module is 1.42 amps (about 16 watts at 12 volts).
Water purifiers are roughly 5 watts for one gallon per minute. If you are just purifying a glass of water, units are available that use a couple of AA batteries (3.5 volts).
A UV lamp is a fluorescent lamp with a quartz "glass" (in case of high efficiency models) and as such is a high voltage discharge tube. Some type of transformer (ballast) is needed to step up the volage to operate the lamp -- these are separate modules or may be built into the lamp base as in the case of compact fluorescent lamps. Voltages are about 150 volts or higher to start the discharge and may drop to 90 volts for operation.
Wires held with tension (clips) can be substituted for sockets (or electrical tape, for example, or wires glued against the contacts).
In the hobby market there are six inch fluorescent lamps. These are operated by 6 volt or 12 volt lantern batteries using a small (1" square) circuit board and draw less than 1/2 amp.
Now, if Christian can supply the description of the lamp purchased from Amazon, maybe a ballast can be found to operate from the 12 volt power supply used for the XO (or maybe from the USB port for low amounts of water). The ideal is to just buy a water purification arrangement that has a ballast that is powered by 5 or 12 volts.
Corbin bought: http://www.amazon.com/gp/product/B0027ND0VO - Christian Bryant