User contributions for Joemck

31 August 2008

• 21:2321:23, 31 August 2008 diff hist +91‎ m Talk:Disassembly bottom ‎ →‎Useless instructions: - screw guide
• 21:1921:19, 31 August 2008 diff hist +207‎ m Talk:Disassembly bottom ‎ →‎Page needs splitting?: new section
• 21:0021:00, 31 August 2008 diff hist +54‎ m Screws ‎ mention the screws inside the handle that don't seem to be doing anything

7 January 2008

• 22:5722:57, 7 January 2008 diff hist +62‎ m Support ‎ added link to Disassembly
• 22:5522:55, 7 January 2008 diff hist −2‎ m Talk:Support ‎ typo in own comment
• 22:5122:51, 7 January 2008 diff hist +261‎ m Talk:Support ‎No edit summary
• 22:4522:45, 7 January 2008 diff hist +5‎ m Disassembly ‎ →‎Re-assembly tips: put screws picture inline

3 January 2008

• 07:3307:33, 3 January 2008 diff hist +107‎ m Support FAQ ‎ →‎The pointer jumps to the bottom-right corner of the screen: - 4 finger salute fixes this one too
• 07:2707:27, 3 January 2008 diff hist +575‎ Talk:Remote display ‎ SSH session glitches

2 January 2008

• 08:0708:07, 2 January 2008 diff hist +493‎ m Disassembly ‎ Added a couple tips from taking it apart again after failing to snap the 2 plastic hooks through their holes

1 January 2008

• 08:3208:32, 1 January 2008 diff hist +4,965‎ Disassembly ‎ Added section about taking apart the bottom part, and pictures of it. (from personal experience)
• 08:2508:25, 1 January 2008 diff hist +211‎ N File:Touchpad-ribbon-cables-out.jpg ‎ Disassembly of the bottom half of a mass-production G1G1 XO-1. Keyboard/touchpad controller with the touchpad cables unplugged. The clear flap on the end of each ribbon cable is helpful in plugging them back in. current
• 08:2208:22, 1 January 2008 diff hist +151‎ N File:Screws.jpg ‎ Disassembly of the bottom half of a mass-production G1G1 XO-1. Photo showing the 4 kinds of screws used here. All are #1 philips head (or is that #0?). current
• 08:2008:20, 1 January 2008 diff hist +224‎ N File:Running-open.jpg ‎ Disassembly of the bottom half of a mass-production G1G1 XO-1. Running the Open Firmware keyboard diagnostic with the bottom half of the XO taken apart. I was working on a stuck Ctrl key. The screen shows it stuck right now. current
• 08:1608:16, 1 January 2008 diff hist +306‎ N File:Magnet.jpg ‎ Disassembly of the bottom half of a mass-production G1G1 XO-1. This lid-switch magnet falls out when you remove the left rail. Also, if you're using a (lightly!) magnetized screwdriver, you might want to use a different one for this screw, since the rotat
• 08:1308:13, 1 January 2008 diff hist +187‎ N File:Left-rail-popped-off.jpg ‎ Disassembly of the bottom half of a mass-production G1G1 XO-1. Removal of the left side rail, showing the two snap locations. I used the nail-clipper handle to slide in to undo the snaps.
• 08:1008:10, 1 January 2008 diff hist +373‎ N File:Kbd-peel-back.jpg ‎ Disassembly of the bottom half of a mass-production G1G1 XO-1. A look under the membrane in a corner of the keyboard. The rubber membrane just presses on a plastic membrane that's sealed onto a circuit board. This makes it more moisture- and dirt-resistan
• 08:0608:06, 1 January 2008 diff hist +118‎ N File:Hinge-closeup.jpg ‎ Disassembly of the bottom half of a mass-production G1G1 XO-1. Closeup of the hinge after unscrewing it from the base.
• 08:0508:05, 1 January 2008 diff hist +214‎ N File:Handle-open.jpg ‎ Disassembly of the bottom half of a mass-production G1G1 XO-1. After removing hinge cover, the top panel of the handle, the green bar along the top, and 4 screws. The remaining 6 screws don't appear to do anything.
• 08:0008:00, 1 January 2008 diff hist +168‎ N File:Glue.jpg ‎ Disassembly of the bottom half of a mass-production G1G1 XO-1. Strip of restick glue that holds down the cable from the touchpad/keyboard controller to the motherboard.
• 07:5807:58, 1 January 2008 diff hist +132‎ N File:Small-screw-icon.jpg ‎ Disassembly of the bottom half of a mass-production G1G1 XO-1. This icon points at the 4 holes that take the smallest kind of screw. current
• 07:5607:56, 1 January 2008 diff hist +308‎ N File:Kbd-tp-ctlr-top.jpg ‎ Disassembly of the bottom half of a mass-production G1G1 XO-1. Top (relative to how you see it when you remove it) view of the keyboard/touchpad controller board. This side faces down when the XO is fully assembled. CN5 connects to the keyboard, CN2 and C
• 07:5207:52, 1 January 2008 diff hist +295‎ N File:Kbd-tp-ctlr-bot.jpg ‎ Disassembly of the bottom half of a mass-production G1G1 XO-1. Bottom (relative to how you see it when you remove it) view of the keyboard/touchpad controller board. This side faces up when the XO is fully assembled. The two buttons at the top of the pict
• 07:5007:50, 1 January 2008 diff hist +88‎ N File:Kbd-top.jpg ‎ Disassembly of the bottom half of a mass-production G1G1 XO-1. Top view of the keyboard.
• 07:4907:49, 1 January 2008 diff hist +91‎ N File:Kbd-bot.jpg ‎ Disassembly of the bottom half of a mass-production G1G1 XO-1. Bottom view of the keyboard.